Goes to the job

Stackable Mat Washer

A trailer-mounted wash station that cleans both sides of the mat and stacks up to 5 clean mats right on the unit.

5 matsstacked on the unit at one time
Under 90 secper 8 x 14 ft composite mat, on average
DOT widthno wide-load permit
14 and 16 ftCLT mats with no deck adjustment
Why the Stackable

No dead time between mats.

Most of a wash cycle is lost waiting for a loader to clear the last mat. The peg pull conveyor keeps mats moving and stacks them as they come out, so the next mat is already washing. Your loader moves a finished stack, not one mat at a time.

Clean composite mats stacked on the Stackable Mat Washer outfeed
Rapid return

One operator, 30+ mats an hour.

BY HAND300 hours

A crew of five washing 450 mats by hand at 20 minutes a mat.

THROUGH THE WASHERUnder 22 hours

The same 450 mats through the mat washer.

ONE OPERATORLoad and supervise

One person loads a batch of 5 and watches the line. Emergency shut-off and low-water pump shutdown are built in.

Brochure example: 8 x 16 ft wood mats at under 2½ minutes each. 30+ mats an hour is our rating for a recent Stackable configuration. Ask us for a payback comparison on your mat count and labor rate.

How it works

Feed it, wash it, lift a clean stack.

Stackable Mat Washer at a mat yard
1

Feed

Load from either side of the unit. Variable line speed lets you match the wash to how dirty the mats are.

Stackable Mat Washer wash box spraying, seen from above
2

Wash

A 360° wash hits top, bottom and edges in one pass. Hot water on demand when the job calls for it.

Clean CLT mats stacked on the Stackable Mat Washer
3

Stack

The peg pull conveyor sets each clean mat on the stack, up to 5 at a time, ready for one lift.

Watch the Stackable run.

See a full stack come off the unit, or walk around the machine in 3D before you call.

Mats it handles

CLT, composite and timber access mats.

  • CLT access mats
  • Composite mats
  • Timber mats
  • 14 ft and 16 ft CLT, no deck adjustment
Built to order

Options you can add.

  • Cold-weather package
  • On-demand hot water
  • Chlorination
  • Built-in flocculation
  • Manual wash stations
  • Truck undercarriage and tire cleaning
  • Demudder for caked mud
  • Decontamination systems
  • Upgraded insulation
  • Multiple pump packages
  • Natural gas heat for stationary units
  • Custom fixtures for your product
What's included

Tested, trained and started up with you.

Tested before it shipsEvery unit is run and approved at our shop first.
Training at our shopYour crew learns the machine before it leaves South Bend.
Start-up on your siteA technician comes out to commission the system with you.
Six months of sparesPump packing, nozzles, hoses and other consumables ship with it.

Stackable Mat Washer specifications.

Stack capacity
Up to 5 access mats on the unit at one time
Conveyor
Peg pull conveyor, variable line speed
Loading
Dual side loading
Wash
360° cleaning, both sides in one pass
Pump packages
40 to 80 GPM at 4,000 PSI, with on-demand hot water to cut oil and grease. Smaller packages are available for tighter budgets.
Transport
Trailer-mounted, within DOT width
Mat sizes
14 ft and 16 ft CLT with no deck adjustment; decks built for mats up to 18 ft long
Water recycling
Closed-loop: debris removal, clarification, oil-water-solids separation, multimedia, carbon and final 20 micron filtering
Wash station base
Built on a clarifier tank with floc and polymer treatment, with an axle and winch pull for moving the station
Moving it
Typically a two-load move. 102 in. wide, under wide load. At the new site you need water, fuel, a lift and dirty mats to start.
Rough footprint
About 8 ft 6 in. wide by 40 to 42 ft long for the wash station on a recent build. Built to spec, so size varies.
Pump house
A 20 ft or 40 ft high-cube container holds the pumps, filtration and controls
Power
Electric. A recent build ran two 20 GPM, 4,000 PSI pumps on 60 HP motors. You supply generator or line power.

Every unit is built to your specifications. Tell us your mats and we size the system.

Stackable questions buyers ask.

Do I need a permit to move it?

No wide-load permit. The unit is within DOT width and is typically a two-load move.

How many mats per shift?

A recent Stackable configuration is rated at 30+ mats an hour, or 240+ in an 8-hour shift, with one operator.

Is it modular?

Yes. Buy the wash station on its own, or a full system with a pump house for pumping and filtration.

Will it run in freezing weather?

Yes, with the cold-weather package. The pump house can be insulated and heated.

What is the lead time?

Every unit is built to order. Ask us for the current lead time.

Can I see one running?

Yes. Watch the videos, walk the Stackable in 3D, or we arrange a visit to a customer running a system.

Does it take both 14 ft and 16 ft CLT mats?

Yes, with no deck adjustment between the two.

Do you train our crew?

Factory training before shipping, start-up training on site, and recorded training videos to refer back to.

What changes the cycle time?

Mat type, how much mud is on it and the pump package. Crews knock off caked mud before loading, and the operator adjusts line speed on the fly.

Do you sell through dealers?

No. Every system comes straight from us, designed and built in South Bend, Indiana.

Tell us your mats. We'll size the system.

Five short questions. We reply within one business day.

What mats do you wash?
About how many a day?
Which washer?