Stays at the yard or moves

All Mat Washer

Our largest, 3rd generation system. One mat in, one clean mat out, from 7 x 14 ft access mats to 40 ft crane and rig mats.

Up to 40 ftcrane and rig mats, 12 in. thick
Under 2½ minper 8 x 16 ft wood mat, on average
20 micronclosed-loop water recycling
250+ galsaved per mat vs typical methods
Why the All Mat Washer

One washer for every mat in the yard.

Rubber, composite, wood or CLT. Access mats, rig mats and crane mats. The single-load conveyor takes them one at a time, so a mixed yard runs through the same machine without a changeover.

Loader feeding a timber mat into the All Mat Washer
Rapid return

450 mats in under 22 operating hours.

BY HAND300 hours

A crew of five washing 450 mats by hand at 20 minutes a mat.

THROUGH THE WASHERUnder 22 hours

The same 450 mats through the mat washer.

ONE OPERATORLoad and supervise

One person runs the line instead of a crew on wands. Emergency shut-off and low-water pump shutdown are built in.

Brochure example: 8 x 16 ft wood mats at under 2½ minutes each. Ask us for a payback comparison on your mat count and labor rate.

How it works

Load, wash, recycle the water.

Loader feeding a timber mat into the mat washer
1

Load

A loader sets the muddy mat on the single-load conveyor. 20 ft is standard; added entry and exit tables take it to 40 ft.

All Mat Washer running a steam test wash
2

Wash

Ten rotating arms and 20 nozzles hit top, bottom and edges in one pass. Shown with the 40 GPM, 4,000 PSI package; other configurations are available.

Solids screen separating mud from the wash water
3

Recycle

Wash water runs through debris removal, clarification, oil-water-solids separation, multimedia, carbon and a final 20 micron filter, then goes back to work. Containing it helps you meet discharge rules and cuts water hauling.

Watch the All Mat Washer run.

See it wash a mat end to end, or visit a customer running one.

Mats it handles

Access, rig and crane mats.

  • Rubber mats
  • Composite mats
  • Wood and timber mats
  • CLT mats
  • 7 x 14 ft up to 40 ft
  • Up to 12 in. thick
Built to order

Options you can add.

  • Cold-weather package
  • On-demand hot water
  • Chlorination
  • Built-in flocculation
  • Manual wash stations
  • Truck undercarriage and tire cleaning
  • Demudder for caked mud
  • Decontamination systems
  • Upgraded insulation
  • Entry and exit tables for 40 ft mats
  • Natural gas heat for stationary units
  • Stand-alone destacker for stacked loads
  • Custom fixtures for your product
What's included

Tested, trained and started up with you.

Tested before it shipsEvery unit is run and approved at our shop first.
Training at our shopYour crew learns the machine before it leaves South Bend.
Start-up on your siteA technician comes out to commission the system with you.
Recorded trainingSessions are filmed and posted online for your crew to refer back to.

All Mat Washer specifications.

Conveyor
Single-load conveyor: one mat in, one clean mat out
Mat length
20 ft standard; 40 ft with added entry and exit tables
Mat thickness
Up to 12 in.
Wash
10 rotating arms, 20 nozzles, 360° in one pass
Cleaning head
Adjustable height for any mat thickness
Pump package shown
40 GPM at 4,000 PSI. Packages run up to 80 GPM, with on-demand hot water to cut oil and grease.
Water recycling
Closed-loop, filtered to 20 microns; 250+ gallons saved per mat
Setup
Mobile or stationary
On site you need
A first water fill plus make-up water, gen-set or line power, diesel for portable hot water
Pump house
A 40 ft high-cube container with the pumps, filtration, lighting, man door and all controls; insulated and heated for cold climates
Rough footprint
Built to spec. A full system is a wash station with conveyor plus a 40 ft high-cube container pump house; station length is set by your longest mat.

Every unit is built to your specifications. Tell us your mats and we size the system.

All Mat Washer questions buyers ask.

Will it handle crane mats?

Yes. Mats up to 12 in. thick; 20 ft is standard and 40 ft with added entry and exit tables.

What does it need on site?

A first water fill plus make-up water, your gen-set or line power, and diesel for portable hot water.

Can I see one running?

Yes. Watch the videos, or we arrange a visit to a customer running a system.

Is it modular?

Yes. Buy the wash station on its own, or a full system with a pump house for pumping and filtration.

Will it run in freezing weather?

Yes, with the cold-weather package. The pump house can be insulated and heated.

What is the lead time?

Every unit is built to order. Ask us for the current lead time.

Do you train our crew?

Factory training before shipping, start-up training on site, and recorded training videos to refer back to.

Can it stack mats too?

Yes. Pair it with a stand-alone destacker to get stacked loading and the single-load conveyor in one line.

Do you sell through dealers?

No. Every system comes straight from us, designed and built in South Bend, Indiana.

Tell us your mats. We'll size the system.

Five short questions. We reply within one business day.

What mats do you wash?
About how many a day?
Which washer?